I'm trying to set up a dedicated server for the house, but I keep ruing into the trouble of having no coection!
I first found out I had no coection when I started to install the server. It reported that it could not coect to the DHCP server, so I set it to configure later, foolishly believing that I could fix it.
(All of these commands were done while in su mode.)
The first thing I did was to apt update to see if it detected the Etheet after installation. It failed to fetch the files.
Then, I looked at lshw -C network to find that my Etheet interface was disabled.
Finally, I took a check at ifconfig and saw that the device eth0 does not exist at all!
So, I tried creating it by adding auto eth0 / iface eth0 inet dhcp and restarting the networking service for the computer to complain that eth0 does not exist (even after restarting!).
This problem traveled with me over two motherboards, yet the etheet cable works for my laptop (which has the same version - 16.04 LTS).
Please, please help me. I don't know what to do.
RIG:
hostname: samserver
Ubuntu Server 16.04 LTS
Motherboard - ASUS H97-Plus
Etheet - Realtek Semiconductor Co., Ltd. RTL8111/8168/8411 PCI Express Gigabit Etheet Controller (rev 11)
ifconfig
Code:
lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:65536 Metric:1
RX packets:2256 errors:0 dropped:0 overruns:0 frame:0
TX packets:2256 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1
RX bytes:167920 (167.9 KB) TX bytes:167920 (167.9 KB)
virbr0 Link encap:Etheet HWaddr 52:54:00:49:f3:01
inet addr:192.168.122.1 Bcast:192.168.122.255 Mask:255.255.255.0
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Code:
# This file describes the network interfaces available on your system# and how to activate them. For more information, see interfaces(5). source /etc/network/interfaces.d/* # The loopback network interface auto lo iface lo inet loopback # Makes `service networking restart` crash auto eth0 iface eth0 inet dhcp
Code:
*-network DISABLED description: Etheet interface
product: RTL8111/8168/8411 PCI Express Gigabit Etheet Controller
vendor: Realtek Semiconductor Co., Ltd.
physical id: 0
bus info: pci@0000:03:00.0
logical name: enp3s0
version: 11
serial: 9c:5c:8e:85:e1:bd
size: 10Mbit/s
capacity: 1Gbit/s
width: 64 bits
clock: 33MHz
capabilities: pm msi pciexpress msix vpd bus_master cap_list etheet physical tp mii 10bt 10bt-fd 100bt 100bt-fd 1000bt 1000bt-fd autonegotiation
configuration: autonegotiation=on broadcast=yes driver=r8169 driverversion=2.3LK-NAPI duplex=full latency=0 link=no multicast=yes port=MII speed=10Mbit/s
resources: irq:27 ioport:e000(size=256) memory:f7c00000-f7c00fff memory:f0000000-f0003fff
*-network DISABLED
description: Etheet interface
physical id: 1
logical name: virbr0-nic
serial: 52:54:00:49:f3:01
size: 10Mbit/s
capabilities: etheet physical
configuration: autonegotiation=off broadcast=yes driver=tun driverversion=1.6 duplex=full link=no multicast=yes port=twisted pair speed=10Mbit/s
Code:
03:00.0 Etheet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168/8411 PCI Express Gigabit Etheet Controller (rev 11)
Code:
# Dynamic resolv.conf(5) file for glibc resolver(3) generated by resolvconf(8) # DO NOT EDIT THIS FILE BY HAND -- YOUR CHANGES WILL BE OVERWRITTEN
Code:
* networking.service - Raise network interfaces Loaded: loaded (/lib/systemd/system/networking.service: enabled; vendor preset:enabled)
Drop-In: /run/systemd/generator/networking.service.d
L 50-insserv.conf-$network.conf
Active: failed (Result: exit-code) since Sat 2016-07-30 21:23:25 PDT: 12s ago
Docs: man:interfaces(5)
Process: 1450 ExecStart=/sbin/ifup -a --read-environment (code=exited, status=1/FAILURE)
Process: 1444 ExecStartPre=/bin/sh -c [ "$CONFIGURE_INTERFACES" != "no" ] && [ -n "$(ifquery --read-environment --list --exclude=lo): ] && udevadm settle (code=exited, status=1/FAILURE)
Main PID: 1450 (code=exited, status=1/FAILURE)
Jul 30 21:23:25 samserver systemd[1]: Starting Raise network interfaces...
Jul 30 21:23:25 samserver sh[1444]: Unknown interface eth0
Jul 30 21:23:25 samserver ifup[1450]: Unknown interface eth0
Jul 30 21:23:25 samserver systemd[1]: networking.service: Main process exited, code=exited, status=1/FAILURE
Jul 30 21:23:25 samserver systemd[1]: Failed to start Raise Network interfaces.
Jul 30 21:23:25 samserver systemd[1]: networking.service: Unit entered failed state.
Jul 30 21:23:25 samserver systemd[1]: networking.service: Failed with result 'exit-code'.
Code:
---- Unit networking.service has begun starting up. Jul 30 21:23:25 samserver sh[1444]: Unknown interface eth0 Jul 30 21:23:25 samserver ifup[1450]: Unknown interface eth0 Jul 30 21:23:25 samserver systemd[1]: networking.service: Main process exited, code=exited, status=1/FAILURE Jul 30 21:23:25 samserver systemd[1]: Failed to start Raise Network interfaces. -- Subject: Unit networking.service has failed -- Defined-By: systemd -- Support: http://lists.freedesktop.org/mailman/listinfo/systemd-devel -- -- Unit networking-service has failed. Jul 30 21:23:25 samserver systemd[1]: networking.service: Unit entered failed state. Jul 30 21:23:25 samserver systemd[1]: networking.service: Failed with result 'exit-code'.
برچسب:
نویسنده: استخدام کار