خرید بک لینک

Hi !

I am new to ubuntu. The etheet got detected until today, and I could use inteet for only one minute or so. Then, even tough is shows coected at the top coer, it doesn't coect. I have searched some forums, and completely made a mess of everything.
Now, I do not find eth0, etheet does not even show up. I need someone to help me.
Thank you.

Some of the output for some common codes:

$ ifconfig

PHP Code:

lo Link encap:Local Loopback
inet addr
:127.0.0.1 Mask:255.0.0.0
inet6 addr
: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU
:65536 Metric:1
RX packets
:742 errors:0 dropped:0 overruns:0 frame:0
TX packets
:742 errors:0 dropped:0 overruns:0 carrier:0
collisions
:0 txqueuelen:0
RX bytes
:404013 (404.0 KB) TX bytes:404013 (404.0 KB)wlan0 Link encap:Etheet HWaddr 60:d8:19:9f:60:d5
inet addr
:10.136.100.140 Bcast:10.136.127.255 Mask:255.255.128.0
inet6 addr
: fe80::62d8:19ff:fe9f:60d5/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU
:1500 Metric:1
RX packets
:10120 errors:0 dropped:0 overruns:0 frame:0
TX packets
:8070 errors:0 dropped:0 overruns:0 carrier:0
collisions
:0 txqueuelen:1000
RX bytes
:9511026 (9.5 MB) TX bytes:1157575 (1.1 MB)
$ sudo lshw -C network

PHP Code:

*-network
description
: Wireless interface
product: AR9285 Wireless Network Adapter (PCI-Express)
vendor: Qualcomm Atheros
physical id
: 0
bus info
: pci@0000:09:00.0
logical name
: wlan0
version
: 01
serial
: 60:d8:19:9f:60:d5
width
: 64 bits
clock
: 33MHz
capabilities
: pm msi pciexpress bus_master cap_list etheet physical wireless
configuration
: broadcast=yes driver=ath9k driverversion=3.19.0-61-generic firmware=N/A ip=10.136.100.140 latency=0 link=yes multicast=yes wireless=IEEE 802.11bgn
resources
: irq:19 memory:f7a00000-f7a0ffff

$ lspci

PHP Code:

.....................................
.....................................
09:00.0 Network controller: Qualcomm Atheros AR9285 Wireless Network Adapter (PCI-Express) (rev 01)
0b:00.0 USB controller: NEC Corporation uPD720200 USB 3.0 Host Controller (rev 04)

$ ethtool eth0

PHP Code:

0
Settings
for eth0:
Caot get device settings: No such device
Caot get wake
-on-lan settings: No such device
Caot get message level
: No such device
Caot get link status
: No such device
No data available

$ cat /etc/network/interfaces

PHP Code:

# interfaces(5) file used by ifup(8) and ifdown(8)
auto lo
iface lo inet loopback
#primary network interfaceauto eth0
iface eth0 inet dhcp

برچسب: نویسنده: استخدام کار تاريخ: جمعه 4 تير 1395 ساعت: 3:47

صفحه بندی