[server] unable to route / configure bonding correctly

Code:

# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).


#eth0 is manually configured, and slave to the "bond0" bonded NIC
auto eth0
iface eth0 inet manual
bond-master bond0


#eth1 is manually configured, and slave to the "bond0" bonded NIC
auto eth1
iface eth1 inet manual
bond-master bond0


#eth2 is manually configured, and slave to the "bond0" bonded NIC
auto eth2
iface eth2 inet manual
bond-master bond0


#eth3 is manually configured, and slave to the "bond0" bonded NIC
auto eth3
iface eth3 inet manual
bond-master bond0


# bond0 is the bonded NIC and can be used like any other normal NIC.
# bond0 is configured using static network information.
auto bond0
iface bond0 inet static
address 192.168.1.151
gateway 192.168.1.100
netmask 255.255.255.0
dns-nameservers 8.8.8.8 8.8.4.4
# bond0 uses standard IEEE 802.3ad LACP bonding protocol
bond-mode 4   
bond-miimon 100
bond-lacp-rate 1
bond-slaves eth0 eth1 eth2 eth3


# The loopback network interface
# auto lo
# iface lo inet loopback


# The primary network interface
# auto eth0
# iface eth0 inet dhcp

Code:

loop
lp
rtc
bonding