[ubuntu] Ubuntu 16.04 Ethernet Help

So, I have recently installed Ubuntu 16.04 (Server). I have Etheet plugged in to the PC that Ubuntu is installed on, but it doesn't let me ping stuff or install packages.
ifconfig -a:

Code:

enp8s0   Link encap:Etheet  HWaddr **:**:**:**:**:**
         inet addr:192.168.1.7  Bcast:192.168.1.255 Mask:255.255.255.0
         UP BROADCAST MULTICAST  MTU:1500  Metric:1
         RX packets:0 errors:0 dropped:0 overruns:0 frame:0
         TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
         collisions:0 txqueuelen:1000
         RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B)
         Interrupt:19

lo       Link encap: Local Loopback
         inet addr:127.0.0.1  Mask:255.0.0.0
         inet6 addr: ::1/128 Scope:Host
         UP LOOPBACK RUNNING  MTU:65536  Metric:1
         RX packets:196 errors:0 dropped:0 overruns:0 frame:0
         TX packets:196 errors:0 dropped:0 overruns:0 carrier:0
         collisions:0 txqueuelen:1
         RX bytes:15016 (15.0 KB)  TX bytes:15016 (15.0 KB)

as for when I ping 198.199.80.11:

Code:

PING 198.199.80.11 (198.199.80.11) 56(84) bytes of data.
From 192.168.1.7 icmp_seq=1 Destination Host Unreachable

the /etc/network/interfaces:

Code:

source /etc/network/interfaces.d/*

auto lo enp8s0
iface lo inet loopback

auto enp8s0
iface enp8s0 inet static
address 192.168.1.7
netmask 255.255.255.0
network 192.168.1.0
broadcast 192.168.1.255
gateway 192.168.1.1

route -n:

Code:

Keel IP routing table
Destination     Gateway       Genmask             Flags Metric Ref    Use Iface
0.0.0.0         192.168.1.1   0.0.0.0             UG    0      0        0 enp8s0
192.168.1.0     0.0.0.0       255.255.255.0       U     0      0        0 enp8s0

ip route show:

Code:

default via 192.168.1.1 dev enp8s0 onlink linkdown
192.168.1.0/24 dev enp8s0  proto keel  scope link  src 192.168.1.7 linkdown

networking.service:

Code:

networking.service - Raise network interfaces
Active: active (exited) since Mon 2016-05-02 21:00:58 EDT; 10min ago

(if you need any more of the networking.service just comment saying so)
ethtool enp8s0:

Code:

Supported ports: [ TP ]
Supported link modes:   10baseT/Half 10baseT/Full
                        100baseT/Half 100baseT/Full
                        100baseT/Half 100baseT/Full
Supported pause frame use: No
Supports auto-negotiation: Yes
Advertised link modes:  10baseT/Half 10baseT/Full
                        100baseT/Half 100baseT/Full
                        1000baseT/Half 1000baseT/Full
Advertised pause frame use: Symmetric
Advertised auto-negotiation: Yes
Speed: Unknown!
Duplex: Unknown! (255)
Port: Twisted Pair
PHYAD: 1
Transceiver: inteal
Auto-negotiation: on
MDI-X: Unknown
Supports Wake-on: g
Wake-on: g
Current message level: 0x000000ff (255)
                       drv probe link timer ifdown ifup rx_err tx_err
Link detected: no

ethtool -i enp8s0:

Code:

driver: tg3
version: 3.137
firmware-version: sb
expansion-rom-version:
bus-info: 0000:08:00.0
supports-statistics: yes
supports-test: yes
supports-eeprom-access: no
supports-register-dump: yes
supports-priv-flags: no

ip neigh show:

Code:

192.168.1.1 dev enp8s0  INCOMPLETE

Please be detailed with your answers, thank you in advance! :D

برچسب: نویسنده: استخدام کار تاريخ: شنبه 18 ارديبهشت 1395 ساعت: 3:34

درباره سایت

آخرین مطالب

امکانات وب

[ubuntu] Ubuntu 16.04 Ethernet Help

صفحه بندی

آرشیو مطالب

پيوندهای روزانه

لینک دوستان

خبرنامه